Free Shipping on Most Orders

wiring to 4ohm

rated by 0 users
Answered (Verified) This post has 1 verified answer | 1 Reply | 1 Follower

Not Ranked
1 Posts
Points 20
rycrow99 posted on Sat, Nov 7 2009 7:34 PM

Equipment:

2 DVC 4ohm 12inch subs

1 2 channel kenwood KAC-7204 amp

Specs:

CEA Rated: 170W X 2 (1.0% THD+N) (4Ohm/2Ch)
250 Watts x 2 (2 ohm)/500 Watts x 1 (4 Ohm Bridged)
• High Quality Speaker Level Input
• Blue Illumination
• High-pass (12 dB per octave) and low-pass (24 dB per octave) filters variable from 50 to 200 Hz
• Variable Bass Boost Control(0-18 dB at 40 Hz)
• Cooling Fan
• MOSFET power supply
• Speaker-level inputs with signal sensing turn-on
• Preamp-level inputs and outputs
• Fuse rating: 40A x 1
•

13-3/4"W x 2-1/4"H x 9-3/8"D

Can I wire as stated in link to get the 4 ohm bridge on the 2 chanell and have it work right?

http://akamaipix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/2DVC_4-ohm_mono.jpg

 

  • | Post Points: 20

Answered (Verified) Verified Answer

Top 10 Contributor
817 Posts
Points 18,123
Moderator
Reply
Answered (Verified) Ninja1283 replied on Sat, Nov 7 2009 8:02 PM
Verified by Ninja1283

If you have two DVC 4ohm subs capable of handling 250W RMS each, the linked diagram will work perfectly. Be sure to adjust the gains correctly, and you should be good to go!

02 BMW 330Ci, Alpine DVI-9965, Alpine MRA F350 5ch, Alpine MRP T220 + 2x Kicker 6x9 FreeAir, Kicker KX1200.1 + Alpine 12" Type-R, 2-Way Security, Keyless Entry, Remote Start

  • | Post Points: 30
Page 1 of 1 (2 items) | RSS