-
Let me start by saying I am a total idiot when it comes to car audio....I need all the experts here to point me in the right direction and answer a couple of questions. I am installing a system in my boat. I am using an Orion HCCA 10d sub in a 1.5 cu. foot ported box. I have a Marine grade MBQuart 2...
-
I just ordered Alpine MRP-F300 and Rockford Fosgate P2L-110, I would like to keep two channels available for later upgrade of my speakers, and use two channels bridged to power the subwoofer. Do I need to buy anything extra like adapters, etc to bridge the outputs? The manual briefly mentions it but...
-
cocolpwts: i just thought of this... if i wire the sub to show 2 ohms, can i just run 2 sets of wires from the sub to each channel of the amp, the amp is rated for 100w x 2 at 2ohms, remember only 1 set of terminals on the box, both channels running into the same set of terminals in the box. will this...
-
The kenwood would work for using on your inside speakers... it will give you 40 watts rms per channel i think. Depends if that is enough power for you. But no, the Alpine amp won't work to power your subs, at least not at the same time really. Since you have two 4 ohm subs, you would either be running...
-
Is this the correct way to wire my set up? /\ /\? Or is this the correct way? V V? Another question, where dooes the power lead go (the wire which tells my amps that my deck is turned on?) Thanks for the help!
-
I have a profile ap.600 2 channel amp with 2 terminal connectors and a visonik dual 10" bass enclosure. my question is how would I wire them both so that the power my amp is putting out is bridged? thank you also my 2nd question is, my subs don't hit hard enough for my liking, I'm thinking its because...
-
Hey c blaze, Okay, if I understand this correctly, with your first question, you are wondering if it's okay to bridge a 2-channel amp, right? The answer is that a 2-channel amp can be bridged. The specs on the amp should list the amount of power an amp can handle in bridged mode and also at what impedance...
-
i have two 2 channel amps one 600w max 170w rms, one 400w and one single voice coil 800w pioneer subwoofer can i bridge my amps together
-
I have a pioneer head unit with a front speaker rca output, and a subwoofer output. I am purchasing a 4 channel amp. My questions are this: number one does the front rca output on my deck control all 4 front speakers, or just the front two speakers? My original plan was to bridge the amp to run the subwoofer...