-
how would i hook up 2 4-Ohm DVC subs in parallel so i can get it down to a 2-Ohm load for my amp i need the subs to be receiving 1200 watts RMS. im using an Audiobahn a2300HCT 4800W Max, High-Current 2-Channel Car Amplifier RMS Power Rating: 300 watts x 2 chan. @ 4 ohms 600 watts x 2 chan. @ 2 ohms 1200...
-
Please forgive my ignorance, but I think I have a factory installed amp below my rear deck. It's a 1990 Ford Taurus. I've read the owners manual and it says nothing about the sound system package. The piece of equipment in question is pretty small for an amp, but it has cooling fins on it and allot of...
-
I have a 2007 mustang gt with the shaker 1000 and i added a kicker 750x
with 2 kicker 12s. The amp remote turn on is wired into accessory. The
signal is wired from the speakers into the amps high level input. when
i play a song, the bass is right. but i get full bass inbetween songs
and even when...
-
Ok just purchased a 2000 Ford Crown Victoria Interceptor and I am replacing the speakers and head unit. I ordered the following and while waiting for them to come i thought maybe i need an amp too but i'm not sure. head unit: Kenwood eXcelon KDC-X492 front speakers: Infinity Reference 6822cf rear speakers...
-
I have an 06' F150 Screw, replacing factory system. Pioneer DEH6900 HU, Infinity Kappa's in the front and Polk db570's in the rear, i really want a sub, but space is limited (and my wifes dosent really like the idea) but i might add one later, so should i go with a 5 channel now, or wait and just add...
-
So I'm planning a new speaker install for my 2000 Mustang GT Vert and not quite sure the best locations for the two amps I plan to use. I have a 50WRMS x 2 MTX & 200WMSx1 MTX sub amp. The smaller amp will power the front component speakers while the sub amp will power a set of 10" RF subs in a dual...
-
its a 2002 Ford F150 with a Dual XDMA7715 head unit and i am trying to connect a Dual XIA3145 Amplifier , the subwoofers going into the car are sony xplodes. wiring the box and the subs to the amp are no problem and have already been done. The amp's power wire has been connected to the battery and the...
-
I will be mounting a Alpine 550 Amp in my F-350 Crew. It will fit under my seat or I have seen pictures of people doing it on the back of the seat. Where is the best placement? I'm thinking the floor wouldn't be the best option if you do a lot of outdoor stuff, dirty, water, etc. If you kept it clean...
-
Hi, I'm purchasing a new stereo system for my F-350 Crew. I purchased a Alpine 550 4 channel amp with a new head unit and new Kappa speakers. The question I have is the following. I was wondering if I could do the following to save a little $$$. I was thinking about putting my front speakers on Channel...
-
Okay, I have read that I need to bypass the factory amp, even our local radio shop mentioned that. Now I'm not an audiophile or anything close. I just want to bypass the amp. Now I've done some research, but not sure if this is all I need todo. I never plan on putting in an aftermarket amp, nor subs...