-
Ok well here it goes, A few weeks ago i put in a system with my stock stereo and it worked just fine. 2 kenwood 12s, legacy 1200 watt amp, and i had to tap into the stock remote wire in the back of the HU (the blue wire). well it worked fine, now that i changed the amp something is not right. I checked...
-
Car - '05 Hyundai Sonata Installed a Sony MEX receiver and discovered the factory amplifier is external, in fact i have not located it yet. I've done the math and with my component speakers i might as well use the installed amp for some added power, to keep up with the 12's. Any thoughts on how to get...
-
First time posting but i have a Sonata with a factory amp and I wanted to know if i added a after market HU will it add more watts to my after market speakers, or will the amp push out the same amount of watts. Because I am tring to detrimine if I should add another amp for the 6x9's in the back?
-
i am not too experienced with car audio other than just swapping head units. my question is: 1) if i am going to hook my sub up to my PYLE pla600 (600 watt, 2 channel) amp, do i need to wire up my aftermarket door speakers in my vehicle, just run aftermarket speakerwire from them, or just leave them...
-
Hey guys it's me again. OK, here's the story. I just installed a decent system in my 2005 Nissan Altima 2.5 SL w/ Bose. You guys helped me alot in deciding how to configure the setup. But now I have a problem. I originally had an Alpine PDX 2.150 amp powering 2 Alpine Type R SPR-17C's 6 1/2" speakers...
-
if i want to install and aftermarket amp and reuse my stock speaker wiring with a set of aftermarket speakers where do i need to tie in my aftermarket amp inputs with the factory system? I was told that I cant take the speaker outputs directly from the back of the radio because the factory amp is not...
-
Ok so i have a panasonic cq-c1300u HU and right now i am running my four interior speakers, 2 6x9s and 2 6.5s both infinity, off of the HU and running a 2 channel amp, sony xm2200gtx, connected to the HU to power 2 12inch infinity subs. I want to add a four channel amp to power the interior speakers...
-
I have a pioneer head unit with a front speaker rca output, and a subwoofer output. I am purchasing a 4 channel amp. My questions are this: number one does the front rca output on my deck control all 4 front speakers, or just the front two speakers? My original plan was to bridge the amp to run the subwoofer...