-
ok, this is my setup; 0 awg wire (150amp fuse) run to D-block. Then 4 awg (60 amp fuse) run to a JBL CS60.4 and another 4 awg (80 amp fuse) run to a kicker zx750. my problem; i recently just got the 0 awg hooked up to hook up both amps simultanesly. When i play the volume loud, 35 out of 40, the bass...
-
I have a infinity 611a mono block sub amp i also have 2 sony octagon shaped subwoofers that are 350 watts rms each my amp is about 425 rms x 1 at 4 ohms and the subs are single voice coil I want to use just 1 sub and wire it to the amp but right now i have two of them in a box and they are both wired...
-
Alright, i finally got the money to make this happen. This is my setup now; All in a 1998 Ford Explorer XLT 4 awg wire to a Kicker ZX750.1 Monoblock amp pushing two 15 CVRs. This is what i plan to add; 4 channel JBL CS60.4 pushing two kicker(or kenwood) 6x9s in bridged mode. The final question is, what...
-
Car - '05 Hyundai Sonata Installed a Sony MEX receiver and discovered the factory amplifier is external, in fact i have not located it yet. I've done the math and with my component speakers i might as well use the installed amp for some added power, to keep up with the 12's. Any thoughts on how to get...
-
I currently have a 2 Channel Pioneer GM5300t Bridged to power a single Pioneer TS-SW3041D . I am looking to purchase a new amp for the sub and wondered if how I can wire my current amp to run my door speakers. I have (2) Infinity Reference 6820cs in the front and (2) Infinity Reference 6822cf in the...
-
i have a zx750.1 with 2 cvrs 15's im planning on getting a JBL CS60.4 pushing 4 6by9s this is what i was planning to do; take out the 4 awg wire, put in 2 awg (with 150 amp fuse) run it to a distribution block (with 80 amp fuse for zx750 and 50 amp fuse for the JBL CS60.4) then split it into two 4 awg...
-
Alright, i know they should both be the same lenth.. but im planning on runing a 2 awg to the d-block, then split into a 4awg and 6awg. for the amp with the 6awg, could i use a 4 awg to ground it? and would i have to ground anything else with a 2awg?? cuz im just running that from the battery to the...
-
i have a kicker zx750.1 pushing 2 CVR's what should my gain be. or how would i set it by ear or by a multimeter. if i set it wrong could it damage the amp or battery?? b/c along time ago i was playing with it and i dont know what i left it at
-
alright. so i was checking out my wires because i was moving my amp (o and i figured out the last post, i blew the fuse so ill just replace that) but as moving it, i noticed that the RCAS, power, and rem turn on were all on the same side of the car, i heard somewhere that they should be on opposite sides...
-
alright. so this is what i did; i moved my amp to a different location, while doing so, cutting off 1 foot and ground and 1 foot of power wire. all this while the negative power cord was off my battery this is what happaned, no bass =---- i later checked it once more and realized that i had accidently...