-
Yes, there definitely should be bass adjustments on the Kenwood. There is also bass boost on the amp. Off for the Alpines and on for the sub ! I would disconnect the cheapo factory tweeters. The Alpines will take care of the highs. You will love that amp.
-
I have a 2007 Jeep Grand Cherokee Overland with Boston Acoustic premium system, that should be made of a 288-watt Digital Signal Processing amplifier and 6 speakers: two 3.5-inch mid- to high-frequency instrument panel mounted speakers, two 6 x 9-inch woofers mounted in the front doors and two 6.5-inch...
-
Hi guys, I'm a car audio virgin so please don't taunt my lack of knowledge. I've been trying hard to learn but am stuck on a few final decisions I need to make. Thanks in advance for your help! I have a Kenwood KDC-MP238 Head Unit in my '83 K5 Blazer. I'm in the process of hooking everything up to a...
-
I have a Kac-8103d and just recently the power light started flashing on it. So I did a little browsing on the net and found out it is a transistor problem. I was wondering if anybody else had had the problem? I have figured out which transistor it is but I have not been able to figure out what replacement...
-
Given that in your other post regarding subwoofers, you referenced 12" subwoofers, then that is what I will bas the response on. The best choice for the Alpine Type S subwoofers is the Kenwood Excelon KAC-X10D amp. If you get two of the Alpine Type R subwoofers, then your best choice is the Kenwood KAC...
-
Due to some filter problems, I have had to replace my factory head unit in my 2001 VW Jetta with a Kenwood. Here is my question... How do I hook up my Monsoon amp to my head unit without using a filter and RCA jacks? There is only one plug on the back of my aftermarket Kenwood head unit. Do I just run...
-
I have a Kenwood KAC-8104D and running it with two Kenwood KFC-W3011 at 4 ohms. I have a 8 ga power and ground to it with a dist block with a 4 ga to the battery. The amp runs fine but after about 15 minutes of play it at about 3/5 of the volume up with the sensitivity/level/gain at .5V the amp is super...
-
Hello stebie weebie, I like this JBL enclosure as well and there are several amps that will work for you in this application. We don't currently carry a JBL mono amp that would be an ideal match for this but some of my other favorites would be the Eclipse XA1000 , Kenwood KAC-8104D , and the MTX X Thunder...
-
I have a 4 ga wire running from my batt to a dist block with two 8 ga wires going to my two amps. One a crunch 75x2. The other one is a kenwood KAC-8104D. My question is, why my kenwood amp keeps shutting off for like a few seconds then come back on. This only happen if the Sensitivity is set at 0.5V...
-
I am getting these kenwood speakers and im not sure what amp i should go with. Any suggestions. here are the specs. They are Kenwood KFC-W3011 Sensitivity : The rating of a loudspeaker that indicates the level of a sound intensity that the speaker produces (in dB) at a distance of one meter when it receives...