-
Welcome to the forums farmerstanton. Since your Pioneer TS-W3001D4 subwoofers handle 1000 watts of power each and you have two of them which when wired together can present a 1 ohm load to an amp, I recommend getting the Pioneer Premier PRS-D2000SPL amp which will output 2000 watts RMS power at 1 ohm...
-
I need someone to please assist me in deciding which amplifier to buy which will best suit my MTX 9512-44 sub. I'm not looking to go over $600.00 for the amp alone, and I was thinking along the lines of Kicker 2500.1 or Kicker 1500.1(750w 4ohms/1500w 2 ohms) or whichever MTX amp would be better suited...
-
I've just purchased (and hope I didn't make a mistake) a new Sony Xplod XM-GTR2022 amplifier. I have 2 new MTX 10" TC510 (thunder 500 series I believe?) subs and a Alpine iDA-X200 deck in case u need to know this. Anyways, from reading the online User Manual for the amp, I don't see any way to properly...
-
Just my opinion here, but a lot of my customers will rate the Kickers pretty high, so I would rate them in this order: 1. Kicker L5 2. Kicker CVR12 3. Rockford 4. MTX 5. Pioneer Of course, a lot of this will depend on what amp you have to power these subs. You have to make sure you match power and impedance...
-
Whats up guys, i recently just purchased the MTX audio TA 4501 amp..it says its 500 x 2 rms but an output power of 1500 watts My my question is...How many watts will I be getting?.... Im very confused , and will it be powerful enough to power 2 kenwood W3011 @300 RMS, and the total output of them is...
-
Hello stebie weebie, I like this JBL enclosure as well and there are several amps that will work for you in this application. We don't currently carry a JBL mono amp that would be an ideal match for this but some of my other favorites would be the Eclipse XA1000 , Kenwood KAC-8104D , and the MTX X Thunder...
-
ok I have two 12" MTX Thunder4500 rated at 225watts rms 4ohms each and I am powering them with a cheap Profile ap1200 amp 200 watts rms each channel. I want to know if I can bridge both the speakers in "series" to the 600 watt set up on this amp with out doing harm to the speakers or amp? I can not go...
-
I have an issue with an MTX Thunnder 720X. The unit continually goes into "protect" mode as soon as it powers up, regardless of speaker load and gain setting. Any thought?????????
-
Hello, I am running an MTX RTP202 Amp to a Thunder 4500 Sub. The amp is connected thru speaker level inputs. Well the other day the amp cut off while I was playin my music. I changed the 20A fuse on the amp,figuring it was just that, but it's not that. I also took all of the connections off of the amp...
-
Is this the correct way to wire my set up? /\ /\? Or is this the correct way? V V? Another question, where dooes the power lead go (the wire which tells my amps that my deck is turned on?) Thanks for the help!