-
I have a 2000 watt rockford fosgate amp in my car along with a 4x100 watt 4 channel rockfor fosgate amp for the component speakers. At high output my lights still dim. I have don the big 3 upgrade, I have a 225 amp alternator and a Kinetik 1400HC battery which I use as my on and only battery. I also...
-
i have a zx750.1 with 2 cvrs 15's im planning on getting a JBL CS60.4 pushing 4 6by9s this is what i was planning to do; take out the 4 awg wire, put in 2 awg (with 150 amp fuse) run it to a distribution block (with 80 amp fuse for zx750 and 50 amp fuse for the JBL CS60.4) then split it into two 4 awg...
-
Alright, i know they should both be the same lenth.. but im planning on runing a 2 awg to the d-block, then split into a 4awg and 6awg. for the amp with the 6awg, could i use a 4 awg to ground it? and would i have to ground anything else with a 2awg?? cuz im just running that from the battery to the...
-
alright. so i was checking out my wires because i was moving my amp (o and i figured out the last post, i blew the fuse so ill just replace that) but as moving it, i noticed that the RCAS, power, and rem turn on were all on the same side of the car, i heard somewhere that they should be on opposite sides...
-
alright. so this is what i did; i moved my amp to a different location, while doing so, cutting off 1 foot and ground and 1 foot of power wire. all this while the negative power cord was off my battery this is what happaned, no bass =---- i later checked it once more and realized that i had accidently...
-
i am not too experienced with car audio other than just swapping head units. my question is: 1) if i am going to hook my sub up to my PYLE pla600 (600 watt, 2 channel) amp, do i need to wire up my aftermarket door speakers in my vehicle, just run aftermarket speakerwire from them, or just leave them...
-
Hi all. I have a 1996 Pontiac Grand Prix GTP coupe. I have a Profile AP 2000 for the amplifier, my receiver is a Pioneer DEH-P6900UB, and the subwoofer is a Rockford Fosgate PL2-212. I have an alternator aswell. This sound system was installed in my vehicle back in October, I have had absolutely no problems...
-
What are the possibilities for powering an amp with AC power, such as what you would plug into the wall in your home
-
I have just finsihed setting up my new basslink and all i have to do is get the power to run through my eclipse amp but when i put the power cable in it works for a second and then if the cable moves slightly the power cuts out on me. The screws to hold the cable in place don't for some reason what could...
-
Ok, i have a few questions about rms and peak power from an amp. ok lets say an amp does 200 watts rms and 400 watts peak. now does this amp perform at these ratings no matter what the gain control is set at or does the amount of watts depend on the setting of the gain control. any help would be appreciated...