-
I am looking for an amp to power my 6.5" momo components. They are rated to handle 125 watts rms. Would the Profile HA1000 or AP1000 be a good amp for this application? Both are 2 Ch's rated at 160 watts rms @ 4 ohms; the momo's are 4 ohms's as well. I could just turn the amp down a bit to compensate...
-
WOW TigerHeli, thanks for the advice and long detailed reply. It is much appreciated. I was able to contact the VW dealer in time and have them halt on installing a new VW battery while I look into other options/alternatives for this situation & get more advice. I have a 3rd car (Nissan truck) I...
-
I recently bought the 1040AP Profile amp from Crutchfield and had it professionally installed by a local dealer. It was put in a 2003 VW Passat. For the most part, all has been great as far as it funtioning properly. Recently, I had to have some engine work done on it by the VW dealer. While in the shop...
-
Hello stebie weebie, I like this JBL enclosure as well and there are several amps that will work for you in this application. We don't currently carry a JBL mono amp that would be an ideal match for this but some of my other favorites would be the Eclipse XA1000 , Kenwood KAC-8104D , and the MTX X Thunder...
-
Hey sup guys, Right now, i only have a pair of Infinity 6022i(60Wrms, 2ohm) and planning to buy a pair of kenwood 1682ie(40W, 4 ohm) for the front and move the 6022i in the rear. I was looking for a nice clean low price amp to avoid clipping(which i'm getting from my $20amp). So, i bought a slightly...
-
Hi all. I have a 1996 Pontiac Grand Prix GTP coupe. I have a Profile AP 2000 for the amplifier, my receiver is a Pioneer DEH-P6900UB, and the subwoofer is a Rockford Fosgate PL2-212. I have an alternator aswell. This sound system was installed in my vehicle back in October, I have had absolutely no problems...
-
my profile ap1200 amp sent out dc current out of one of the channels it toasted my old mtx woof,then i hooked up a brand new kicker comp 10"started to toast that one called kicker told me to check speaker outs for dc and the bad one had it the other was fine .i then put the kicker on the other channel...
-
Personal recommendation is to either run the 12-inch Sony by itself or the 10-inch Alpine's by themselves and either sell the remaining subs or use them in another vehicle. That's not what you want to hear, though, but you don't have a lot of options here. Option 1 (best) would be to find a 400W RMS...
-
I am trying to run a dual amp set up fpr my wake board boat and here is my dillema. I have a Kenwood KDC-225MR (HU) with an older Sony (6ch) XM3060 amp which I intend to use only for the existing 6 Kenwood speakers in the boat. The Sony has 6 RCA in jacks A/B (front), C/D (mid) and E/F (rear)/(sub)....
-
I am currently using a Profile AP700M to drive my one 12" Alpine Type R 4ohm DVC (wired as a 2ohm load) in a Q logic Type 2 box sealed. I am fairly happy with the amp but feel like I am not getting the full potential out of the sub with the Profile. I am considering the Alpine MRP M450 or the Kenwood...