-
alright. so i was checking out my wires because i was moving my amp (o and i figured out the last post, i blew the fuse so ill just replace that) but as moving it, i noticed that the RCAS, power, and rem turn on were all on the same side of the car, i heard somewhere that they should be on opposite sides...
-
HEADUNIT JVC EXAD KD-AVX11 (In Dash DVD/CD player) 2.7" Wide Screen FRONT SPEAKERS (Front Doors) Pioneer TS-C160R 16.5cm Kevlar (Yellow) 250 Watts Max. 60 Watts Nominal Rating + Tweeters + "Passive Crossovers" REAR SPEAKERS Pioneer TS-D161S 16cm Kevlar (Yellow) 260 Watts Max. 60 Watts Nominal Rating...
-
Deck: CDE-9874 (only 2 pre-outs) Front and Rear/Sub 4-Channel Amp: Alpine MRP-F450 running Alpine Type-R Speakers front and rear That is my current setup, now I have just purchased a Type R 10" Sub and The MRP-M850 Amp to run it. I might run two subs later on so I bought an amp with more than enough...
-
OK, I can't seem to find an answer to this anywhere, so I'm hoping you guys can help. In the past, I had a 4-channel amp with preamp outputs, so daisy-chaining a 2nd sub amp was easy as pie. But that system's long gone. I really want Crutchfield's Rockford Fosgate P400-4 to drive my front 4 but it doesn...
-
Ok so i have a panasonic cq-c1300u HU and right now i am running my four interior speakers, 2 6x9s and 2 6.5s both infinity, off of the HU and running a 2 channel amp, sony xm2200gtx, connected to the HU to power 2 12inch infinity subs. I want to add a four channel amp to power the interior speakers...
-
i have an infinity 5761a amplifier here is my setup 2 4ohm kenwood door speakers in front 2 2 ohm infinity kappa 693.7i in the rear deck and i have 2 jl audio 10w3d4 10 inch subs. my first question is how to properly wire the subs if i have to i dont mind just running one of them and bridging the amp...
-
I have a pioneer head unit with a front speaker rca output, and a subwoofer output. I am purchasing a 4 channel amp. My questions are this: number one does the front rca output on my deck control all 4 front speakers, or just the front two speakers? My original plan was to bridge the amp to run the subwoofer...
-
Typically the Amp will have a low-level side and a high-level side input and this might be why there are 2 sets of RCA inputs on the amp in question. You should not need to plug in on both of the RCA inputs to make the amp function properly... In fact, that'd be the first time I've ever heard...
-
im going to have to subwoofer amps and its going to have 4(2 pairs) rca ends soooooo if my receiver has only 2(1 pair) of non fading subwoofer input then would i have to buy 2 y adaptors? Also i bought 19.4 ft of rca's and im pretty sure thats more than enough what do i do with the extra slack?