-
I'm trying to decide between 4 Kicker 12" SVC 8 ohm subwoofers or 4 Sony 12" DVC 4 ohm subwoofers. I have a Kicker 2 ohm Class D amplifier. The system will be in a full size Chevy Blazer. I am looking for high db.s as well as great sound quality. I would consider other setups but am looking...
-
I just got two sony xplod 10'' 600w max subs. The subs are the older model of the xplods and I don't know the rms or ohms for sure, I figure that the rms would be around 300w to each sub. I am now in a place to by an amp, however I don't know what would be best. I don't have a lot of extra money. Also...
-
I am thinking of purchasing 2 Infinity 1260w subs and paralell wiring them to a Sony Xplod-ZZR3301 Mono sub the amp has an rms of 600 at two olms and the subbs are 4 olms with rms of 300w each. According to the guides and such this should work but unsure. I am looking to have good sound, loud enough...
-
k like the title says i got 2 800 sony watt amps and 1 1400 watt visonik sub . right now its one amp bridged to each coil side. i dont belive that this is the proper way but has been going strong for just over a year now. but since im building a new box.. havnt decided what kind yet.. maybe fiberglass...
-
I just got a Sony XS-L121P5 subwoofer here is a link to the sub: http://www.carsound.com/articles/publish/printer_17.shtml I still need an amp and I was looking at getting this one Sony XM-2002GTR http://xplodsony.com/xplod/amplifiers/XM-2002GTR I'm getting it for 100 bucks though, but i've been doing...
-
I am running two pioneer 12" ts-w306dvc subs in a ported box off a cute little sony xplod amp (xm-sd22x), lol. Now I've grown up and realized this isn't going to cut it. I have everything wired up like the "Two Subwoofers, Mono Amp" diagram here (http://akamaipix.crutchfield.com/ca/learningcenter/car...
-
i really need to know this guys so if you could help me out i would greatly appreciate it. i need to know whether or not the amp is going to have enough power to really put some pound into that sub if i bridged it. also i would like to know if you guys know of any way to fit a high-output 12" sub box...
-
if i bridged a sony xm 2002gtr and hooked it up to a 2ohm dvc alpine type r would it be safe for the amp and speaker
-
I've been trying to read up on a lot that I could find... still this gets so confusing with Ohm's and watts and such. I am using the Alpine SWR-1042D sub. Nice and fits in my firebird well. I am using an older Amp I had laying around for this because I don't have money yet for a new one. That Amp is...
-
I have replaced the factory deck with a Sony 4x50 watt deck (no subwoofer outputs). The factory subwoofer ties into all 4 channels (2 front, 2 rear). My wiring is getting power and feed to the subwoofer, but the volume is very low and the crossovers seem to be ineffective. The subwoofer is also affected...