-
System Specs: Pioneer GM-X862 Maximum power output --- 250 W × 2 / 760 W × 1 Continuous power output --- 125 W × 2 (at 14.4 V, 4 Ω, 20 — 20,000 Hz, 0.08% THD) 380 W × 1 (at 14.4 V, 4 Ω, 20 — 20,000 Hz, 0.8% THD) 190 W × 2 (at 14.4 V, 2 Ω, 20...
-
I recently purchased 2 15 inch kicker cvr's with rms 500 and max 100. they are in a ported box. should i go with a mono amp, 2 channel? how much watts should i power them with? Thanks for the help- mack
-
I've been looking for a good, efficient, moderately priced system. I was leaning towards these Kenwoods . Also I liked these Rockfords . I'm not sure what to do. I'm also not sure what amp to get to power either. Anyone want to help? I'm just interested in a quality system for the price...
-
Had such good luck with info from Tiger Heli and Ninja 1234 thought I'd try again; let's just say it's a tough week electronically. I live in an area of constant power surges, brown outs and brief outages. There is a backup generator (on a 2 second delay) in case of blackouts and professionally...
-
I have a 2004 Audi A4 with Premium Sound (Bose) and I bought a 12" JL Audio W3v3-4 (4-ohms) and I wanted to know what Amp I should buy to go with it?? I want an amp that can handle the one 12" JL Sub and also run to my stock Bose speakers. What do you recommend?
-
I have an Alpine MRPK300 Amplifier which was working fine when I pulled my car into the garage. When I left again an hour or so later, the amp was clipping so badly that I could not listen to any audio source except at extremely low volume. The system was bought about a year ago from an unreputable dealer...
-
Let me start by saying I am a total idiot when it comes to car audio....I need all the experts here to point me in the right direction and answer a couple of questions. I am installing a system in my boat. I am using an Orion HCCA 10d sub in a 1.5 cu. foot ported box. I have a Marine grade MBQuart 2...
-
Alright so I just got a new car (2009 Nissan Cube 1.8S with 4 6.5" speakers and 2 tweeters). I also have a Kicker L5 sub (Kicker 06TS10L5) with a kicker 400.1 amp. Now I can buy another one (used) for $80 or I can try to sell my L5 to pick up one L7 12" Now money isn't readily available...
-
ok, this is my setup; 0 awg wire (150amp fuse) run to D-block. Then 4 awg (60 amp fuse) run to a JBL CS60.4 and another 4 awg (80 amp fuse) run to a kicker zx750. my problem; i recently just got the 0 awg hooked up to hook up both amps simultanesly. When i play the volume loud, 35 out of 40, the bass...
-
I am building a fiber glass box for three kicker comp vr 12's for dodge ram quad cab. I was wondering if I could put all three subs on a single port and if so would the port volume be? The same as for just one cvr? Please help