-
System Specs: Pioneer GM-X862 Maximum power output --- 250 W × 2 / 760 W × 1 Continuous power output --- 125 W × 2 (at 14.4 V, 4 Ω, 20 — 20,000 Hz, 0.08% THD) 380 W × 1 (at 14.4 V, 4 Ω, 20 — 20,000 Hz, 0.8% THD) 190 W × 2 (at 14.4 V, 2 Ω, 20...
-
I recently purchased 2 15 inch kicker cvr's with rms 500 and max 100. they are in a ported box. should i go with a mono amp, 2 channel? how much watts should i power them with? Thanks for the help- mack
-
I have a 2004 Audi A4 with Premium Sound (Bose) and I bought a 12" JL Audio W3v3-4 (4-ohms) and I wanted to know what Amp I should buy to go with it?? I want an amp that can handle the one 12" JL Sub and also run to my stock Bose speakers. What do you recommend?
-
I have an Alpine MRPK300 Amplifier which was working fine when I pulled my car into the garage. When I left again an hour or so later, the amp was clipping so badly that I could not listen to any audio source except at extremely low volume. The system was bought about a year ago from an unreputable dealer...
-
Let me start by saying I am a total idiot when it comes to car audio....I need all the experts here to point me in the right direction and answer a couple of questions. I am installing a system in my boat. I am using an Orion HCCA 10d sub in a 1.5 cu. foot ported box. I have a Marine grade MBQuart 2...
-
ok, this is my setup; 0 awg wire (150amp fuse) run to D-block. Then 4 awg (60 amp fuse) run to a JBL CS60.4 and another 4 awg (80 amp fuse) run to a kicker zx750. my problem; i recently just got the 0 awg hooked up to hook up both amps simultanesly. When i play the volume loud, 35 out of 40, the bass...
-
I'm looking at getting 2 infinity 1052Ws (4 ohm DVC) or maybe going with 2 1062ws or 1262ws (basically any 2 infinity subs that are DVC and get 50% off one) and powering them with a clarion dpx11551 850 watts RMS x 1 at 4 ohms (1,550 watts RMS x 1 at 2 ohms). I'm not looking to spend a ton on...
-
At the moment its a pair of older kickers, no idea...gonna just try them to see if they are too old for now, will replace if I have to. But they appear to be in perfect condition being inside bandpass boxes...Not getting my hopes too high, but willing to at least check them out first. I wish there was...
-
I just bought 2 of these Infiniti subs (awesome deal) to go in a custom enclosure under the rear seat of my 07 Sierra Denali. They are dual voice coil 4 ohms, and I read on the sight that a 2 channel amp would be preferred for this type of sub, instead of a mono amp. They handle 250 RMS each. I have...
-
I have an LA Sound Ventura 280 SX 2 amp that I purchased from a friend. It is old and the specs on top are scratched, so it is hard to read them. One of the side panels is also missing, so I am not sure what the features on that side are. Does anyone have any information on this amp or happen to know...