-
I am in the process of putting together my system and have several questions. First here is what my setup will be. 15" Kicker Solo Baric L7 Dual 4-Ohm, wired down to 2 Ohms for 1,000 watts rms. Custom Enclosure CUSTOM ¾" MDF ENCLOSURE 3.0ft^3 Net Volume Slot-Port Tuned @ 35Hz ¾" MDF with 1¼" Front Face...
-
This is what I am putting together. This is a everyday driver. 1992 Buick Roadmaster Limited Sedan 200 amp Ohio Generator alternator 7806-200 Kinetik HC1800 under the hood Alpine IVA-D105 Alpine TUA-T550HD Alpine DHA-S690 Alpine PND-K3 Audio Control Epicenter Audio Control Three.1 Kicker SXRC Kicker...
-
I have a Kicker 750.1 amp rated at 930 watts RMS powering my 15" kicker L7 which is rated at 1000watts RMS/2000watts max. I am trying to save money but yet I have put a lot into my system so I need a cap that I can rely on but at a cheap cost. Thanks
-
alright so i have a few q's and in mulitiple threads ive read people on this site have been very helpful so i hope i can get some of my problems solved. first of all i have a 00' pontiac grand am SE 2 door. i have a jvc HU with built in hd radio i think its kd-hd-30 to be exact. i recently installed...
-
i have a kenwood x40 amp(interior) and a mtx x500d(500watt rms) running a 12 inch dvc boston g5(450rms).do i need a capacitor?
-
I have a 45' boat in which the bass cuts out when the volume is up. I bought a capacitor to help with the current load as I have 600 amp hours of AGM batteries unfortunately they are rather far from the stereo system and I would have needed wire the size of my thumb to carry the amps that far. I put...
-
I have a JL Audio 1000/1 running a 12W7 and a ~500 watt Infinity running 4 6.5 speakers. The 1000/1 is hooked up to a 2 farad power acoustic cap but when I crank the bass the lights dim in beat with the music. I have not done a "Big 3" upgrade yet but I would like to know if I also need to get a new...
-
ok my headlights dim a little when the subs hit a "thud" but no dimming on the extended bass so would i need a capacitor?
-
I'm putting a new system in my truck but I've never done one this big before. It's 4 12"s that are pushing 2000 watts peak and 1000 rms out of each and then I also have 20 6.5" speakers each one pushing 400 watt peak and 200 rms per speaker. I know I need atleast 400 amp charging system so I plan to...
-
I recently installed a capacitor in order to prevent my lights from dimming for my 500/1 & 12w7 combo. When I went to charge the cap as part of the installation the meter at the top of the cap read only 8.9 volts. Actually when I first connected the charging resistor the charge was 8.9 and began...