-
So i'm going to buy an alpine mrp-m500 amplifier to connect to a 10" type-r (4ohm)and I will wire it in parallel for a 2 ohm load on each coil..my only questions are what size wiring should I use to connect my amp to my HU, the distance is about 5-8 feet, I was also wondering what size fuse...
-
You need to do what is known as the Big 3 Upgrade. Larger than stock high quality copper wiring, at least 4 gauge, from battery negative to chassis ground, from engine ground to chassis ground, and from battery positive to alternator positive. Clean any dirt, grease, oil, paint, etc. from grounding points...
-
I have a infinity 611a mono block sub amp i also have 2 sony octagon shaped subwoofers that are 350 watts rms each my amp is about 425 rms x 1 at 4 ohms and the subs are single voice coil I want to use just 1 sub and wire it to the amp but right now i have two of them in a box and they are both wired...
-
A 2 farad cap will work nicely. Use at least 4 gauge wire from battery to cap to amp and also ground. Use an 80 to 100 amp inline fuse as close to the battery as possible. Rock on !
-
Car - '05 Hyundai Sonata Installed a Sony MEX receiver and discovered the factory amplifier is external, in fact i have not located it yet. I've done the math and with my component speakers i might as well use the installed amp for some added power, to keep up with the 12's. Any thoughts on how to get...
-
I have 2 -10" audiobahn Q-flame series subs at 900 watts RMS a piece and i need to decide on an amp. Whats the best bang for my buck deal ($200-300) and how would i want to go about wiring both dual coil subs and how about just one sub? whats the popular amp on the market for intermediate car audio enthusiasts...
-
On the chart u gave me, i filled everything out, but what makes the biggest different in between deciding whether a 2 awg or 4 awg should run to the distro box is the length. If i put15 feet in, it says 4awg, but when i put 17 feet in, it says 2 awg. i dont know how many feet it is right now, but it...
-
I just installed my first capacitor a couple of days ago. I have an Alpine MRP-M1000 that has 1/0 running from the battery to a distribution block. I have 4 gauge running from the block to the cap, cap to amp, and amp/cap to ground distribution block. Then I have 1/0 running from the ground block to...
-
I've just purchased (and hope I didn't make a mistake) a new Sony Xplod XM-GTR2022 amplifier. I have 2 new MTX 10" TC510 (thunder 500 series I believe?) subs and a Alpine iDA-X200 deck in case u need to know this. Anyways, from reading the online User Manual for the amp, I don't see any way to properly...
-
I have an old school Rodek 2300i 2 channel amp, and a Rodek crossover. I have one 15" MA audio dual voice coil sub and need to know the best way to wire it. Help please