Free Shipping on Most Orders

Browse Site by Tags

Showing related tags and posts across the entire site.

  • Problems with my dual subs

    I have installed 2 12' 4 Ohm CVR124 to a 2006 2-channel Fosgate p5002 amp and when i bridged them, one of them (right one) makes a popping sound and it flutters more than the left one. So i did an experiment on both of them. I would just wired one of the subs (left one alone than the right one alone...
    Posted to Subwoofers by Phil My Wang on Fri, Jan 16 2009

  • amp, speakers, whole setup.

    i am not too experienced with car audio other than just swapping head units. my question is: 1) if i am going to hook my sub up to my PYLE pla600 (600 watt, 2 channel) amp, do i need to wire up my aftermarket door speakers in my vehicle, just run aftermarket speakerwire from them, or just leave them...
    Posted to Amps by vito45 on Thu, Oct 23 2008

  • Profile Amps, Good or Garbage?

    I am looking for an amp to power my 6.5" momo components. They are rated to handle 125 watts rms. Would the Profile HA1000 or AP1000 be a good amp for this application? Both are 2 Ch's rated at 160 watts rms @ 4 ohms; the momo's are 4 ohms's as well. I could just turn the amp down a bit to compensate...
    Posted to Amps by Nick Jones on Wed, Oct 8 2008

  • Help with amp and speakers.......

    I was given an MDX-2642 1200w 2channel 2ohm stable amp and 2 12" kicker cvr....I have just purchased a pioneer indash p4000 and want to know how to wire the amp so I can have maximum power.
    Posted to Amps by BigBB on Sat, Aug 2 2008

  • Help Matching An Amp And Subs

    Hey guys its me the newbie again! I wanted to get some expert advice from you guys. I just purchased 2 subs and an amp and would like to know if they are compatible with each other. In other words I want to know if I made the right choice in the subs and the amp because I dont want to blow the speakers...
    Posted to Amps by thomas1097 on Mon, May 19 2008

  • 4 ohm amplifier with 2 or 8 ohm subwoofer???

    I just bought a new subwoofer to put in my car as I blew out my old Kicker 12", but I'm realizing that I might have made a big mistake. I have a Rockford Fosgate Punch 301S amp that is currently bridged out at 4 Ohms with 300 watts. It can also be wired at 2 ohms with 2 channels at 150 watts. I purchased...
    Posted to General Car A/V Discussion by ATrain on Sun, Feb 17 2008

  • Sub wiring question?

    Sub wiring question? I have 2 (4) ohm DVC speakers, I have a 1000 watt bridgeable 2 ch 2 ohm stable amp I have each speaker wired in parallel, wired to each channel on amp. Am I able to bridge the speakers at the amp and if so what impedance would that be
    Posted to General Car A/V Discussion by Mitsubishi D on Sun, Jan 6 2008
Page 1 of 1 (20 items)