Showing related tags and posts across the entire site.
-
I have 2 Alpine SWR-1242D subwoofers. And I've been told that I should get two amplifiers, one for each sub. Now, is this really necessary? If I do need 2 amps, I'm planning on getting the Alpine PDX-1.600. If not, I would like to get the JL Audio Slash v2 1000/1v2 to power both subs. If anyone could...
-
Specifically, are the 12" subs the 2-ohm DVC or 4-ohm DVC version? If they are 2-ohm, then you can wire them to a mono amp that can handle a 3 ohm load. If they are 4-ohm, then you can connect them to a mono amp that can handle a 2.7 ohm load. Here is a wiring diagram for 3 2-ohm DVC subs to a mono amp...
-
Is this the correct way to wire my set up? /\ /\? Or is this the correct way? V V? Another question, where dooes the power lead go (the wire which tells my amps that my deck is turned on?) Thanks for the help!
-
ok so i just bought 2 mtx 4500 12"(SVC) subs they are rated from 50-225 rms each...and the amp i want to get is the kenwood KAC_9103D mono amp rated at 900 watts RMSx1 at 2 ohms just in case i want to expand my horizon when i get older and get a job and can spend more money on my vehicle....but my problem...
-
To power two subwoofers is it better to use a mono amp or a 2channel amp? This ? is using 2 DVC 2ohm subwoofers, wired at a 2 ohm load(parallel).
-
I would like to purchase an amp and a sub in the near future and I was wondering what the best combinations would be? I think I would like to get a 2-ohm DVC sub, and a 2-channel amp, with the sub wired so the amp sees 4-ohms. However, I would go with a mono-block and a DVC at 2-ohms if it makes the...
-
Hello, very new to car audio. I have a sony "monoblock xmsd51x " From what i remember when I was first purchased this amp its rated at 1100w max.... my question is if I purchase the Kicker Comp VR 07CVR122 or Kicker Comp VR 07CVR124 I was looking at getting two of them... Will either one of these work...