Showing related tags and posts across the entire site.
-
Hey everyone. I posted here before when I was upgrading my speakers and received a lot of really helpful advice, so I'm naturally returning with my new situation. I'll explain what I'm looking to do and then post the specifics about my current system: I currently have MB Quart speakers for my front and...
-
The Bose sound system has lost sound except for the driver's side. Actually, the rest of the car gets sound except during warm weather, which in South Mississippi means 10 months of mono sound and two months +/- of great sound. The Audi dealer says the amplifier needs to be replaced ($1,216 for part...
-
I have 2 Alpine SWR-1242D subwoofers. And I've been told that I should get two amplifiers, one for each sub. Now, is this really necessary? If I do need 2 amps, I'm planning on getting the Alpine PDX-1.600. If not, I would like to get the JL Audio Slash v2 1000/1v2 to power both subs. If anyone could...
-
i have a 2001 toyota camry thats mostly stock audio-wise. i have 2- 6.5" Sony Xplods (XS-R1643) 270W Peak, and 2- little dome tweeters in a box in the back seat and i just hooked the wires from them to the factory 6"x9"s in the back window. i just bought 2 Pioneer Subs (TS-W252R) they're 10" 4-ohm, 50W...
-
i am not too experienced with car audio other than just swapping head units. my question is: 1) if i am going to hook my sub up to my PYLE pla600 (600 watt, 2 channel) amp, do i need to wire up my aftermarket door speakers in my vehicle, just run aftermarket speakerwire from them, or just leave them...
-
I am looking for an amp to power my 6.5" momo components. They are rated to handle 125 watts rms. Would the Profile HA1000 or AP1000 be a good amp for this application? Both are 2 Ch's rated at 160 watts rms @ 4 ohms; the momo's are 4 ohms's as well. I could just turn the amp down a bit to compensate...
-
i havent used my amp or capacitor in over 2 years, and they were working fine when i took apart my old system. however, i cant just hook the amp up to someone else's ride though because my amp is a crossfire 1000d (runs 500x2 @ 2 ohms, 1000x1 @ 1 ohm rms), and obviously im not just gonna screw up someone...