Showing related tags and posts across the entire site.
-
Ok. I figured I would just put the two different questions into one post to keep everything in one place. I currently have a Kenwood excellon kdc-x469 head unit which I want to replace. I was looking at either the Kenwood Excellon KDC-X792 or the Excellon KDC-X890. I was figuring on sticking with kenwood...
-
i am not too experienced with car audio other than just swapping head units. my question is: 1) if i am going to hook my sub up to my PYLE pla600 (600 watt, 2 channel) amp, do i need to wire up my aftermarket door speakers in my vehicle, just run aftermarket speakerwire from them, or just leave them...
-
i have an 02 altima, purely stock currently . i want to put in it a jensen vm9022 which puts out 18w x 4 ( here ). the speakers i want to run are jl audio vr650-cxi ( there ) and vr690-cxi ( elsewhere ). the 650's have a max rms of 60 watts and the 690's have a max rms of 80 watts. i also want to run...
-
Hey guys it's me again. OK, here's the story. I just installed a decent system in my 2005 Nissan Altima 2.5 SL w/ Bose. You guys helped me alot in deciding how to configure the setup. But now I have a problem. I originally had an Alpine PDX 2.150 amp powering 2 Alpine Type R SPR-17C's 6 1/2" speakers...
-
I have been anxiously awaiting this final step to my setup. Currently have in my Ford Explorer (2 door) the following: HU: Alpine 9887 Speakers: 5x7 Alpine R's (front and back) Subwoofer: JL audio 10w7 in custom ported box Amps: 1 Alpine MRP-F450 (running the speakers) and 1 JL audio 500/1 (for the sub...