Showing related tags and posts across the entire site.
-
Now, I know everyone says it's not a good idea to put a new sub into the location that a 350Z comes with from the factory, but I tend not to listen to what other people think. What I was wondering was, from looking at the mounting hole and clearances, it concerns me that there is very little room, at...
-
Ok heres the story. I have a 1992 Chevrolet Camaro (Third Gen) T-Top hatchback. I have avenues of approach for subwoofers. I have the Choice between a single JL Audio 12W7 or... A pair of JL Audio 12W6V2's Either would be powered with a JL 1000/1 amp but im torn between the two. I have not been into...
-
Here's myself The 2001 Lamborghini Was installed in the fall of 2007 and will be featured in Car Audio Magazine in February of 08. The install was made using all Exile Car Audio Equipment. A low profile 10" Exile X-tec sub is placed behind the passenger seat and X-tec component speakers were used in...
-
How hard would it be to wire 2 head units to work in the same vehicle? I have the Kenwood Excelon KDC-X991 and Im thinking about adding a cheap 7 inch flip out monitor DVD HU > like a Jensen or Dual ($400-$500). My reasoning in doing this is I love the way my kenwood looks and sounds and I cannot...
-
How would I wire in a speaker that is going to be mounted in the center of the top of a dash? I don't just want to wire it as a side speaker because i have lots of music that creates surrounding sounds, I would love to have it create that "center" sound. Thanks!
-
this is teh sub placing im thinking about,plz help me to say if this is a good way to mount,im getting two 10" kicker subs
-
I am looking for any instructions, tips on getting 14 gauge wire to the front doors on my Mazda 5. I would like to use the rubber grommet that the factory speakers use to run from the dash to the speakers in the doors. The amplifier I purchased at Crutchfield recommends running nothing less than that...